There are two main types of cable television installations: pre-wiring
and wiring after the finishing work on a home is done. If at all
possible, pre-wire your home for cable, satellite, or install an antenna
for better television reception. Of course that's not always possible,
especially if you're buying an older home. Luckily, cable installation
is a flexible project and there are alternatives. Here are a few
thoughts and guidelines you'll want to consider to get your premium
television services up and running.
Think Ahead—Pre-Wiring Cable
By far the easiest route when it comes to cable installation is
pre-wiring your home when it's being built. That means installing all
the wires prior to putting up the drywall. Here are a few suggestions to
help you get rolling:
Buy quality cable wire. Most cable wire sold at hardware
stores is inferior to that used by cable installation companies and
providers, meaning poorer picture quality. Talk to your cable provider
about purchasing pre-cut cables directly from them. Most providers will
be happy to comply.
Run all connections individually back to the point of origin. Instead
of splicing into wires in the crawl space or attic, run each hookup
back to the same point where the cable enters the home (otherwise known
as the point of origin). Again, you'll have better picture quality and
it will be easier to perform repairs.
Run a wire to every room in the home. Even if you're
not planning on activating cable in every room, it's a lot easier, and
cheaper, to pre-wire each room than to try to run cable later. Also,
keep in mind that many cable providers also provide internet access over
the same lines, so be sure you cover your bases there, including kids'
rooms and the office/den.
Don't worry about faceplates, etc. Your cable
company should take care of this when they come to install/turn on your
cable. If you're not turning your cable on right away, faceplates can be
bought cheap at just about any hardware or home improvement store.
If You're Too Late to Pre-Wire
If you've purchased a house that's already been finished, there's still
hope. First of all, if you've got an unfinished basement or crawlspace
then you're still in good shape. Most suggestions for pre-wiring still
apply, with a little extra work necessary to get those wires the final
few feet up into the appropriate walls. If your basement is finished or
you don't have a crawlspace, you'll have to run wires through the attic
or along the exterior of your home. Before performing this type of cable
installation, be sure to plan ahead where you want your cable to run,
and drill all holes with a downward angle to prevent rain and other
moisture from getting inside your home.
Finally, keep in mind that cable installation of these types are easily
performed by your cable provider and are often included in installation
and setup. In other words, unless you've got to do it yourself, leave
the headache to them.
Install Antenna for Your TV
If you're one of the diehards still refusing to pay for your television,
you might want to install antenna to enhance your television reception.
All the wiring considerations remain the same, and since all
broadcasters are required to switch over exclusively to digital (also
known as high definition, or HDTV) broadcasting by February 17, 2009,
it's probably not a bad idea to get a jump on things and invest in an HD
antenna anyway.
